Sliding Door Repair Parts - Sliding Door Replacement Rollers - Sliding Door Tracks - Weather Stripping
silver screen door track cover

Aluminum Sliding Screen Patio Door Rail Cover - Silver - 5/8 inch Wide

Regular price $41.95 Sale

Sticking Sliding Screen Doors can sometimes stop sticking using a Sliding Screen Door Track Cover in Silver

For sliding screen doors where the existing sliding screen door rail is worn down or broken off.  These covers fit virtually ALL sliding screen doors. 

A lot of times, the springs in the screen door rollers or wheels get weak, even if the wheels or rollers are in good shape, causing the sliding screen door to bottom out and stick.  These raise the sliding screen door up so it can't bottom out and stick.

Sliding screen patio door rail covers are designed to come to a point where sliding screen door rollers ride so that the sliding screen door rollers "hold onto" the rail. They are 5/8 inch wide (give or take 1/8 inch) with the point right in the middle.

To fix the sliding screen door track, simply remove the sliding patio screen door, place rail cover over existing rail, glue into place and replace the door. How simple is that?

Screen door rail covers are raw silver aluminum.

Aluminum Sliding Patio Screen Door Rail Cover comes with a tube of adhesive and Installation Instructions.

4 foot and longer pieces shipped in 1-1/2 inch PVC with end caps to help insure it doesn't get bent. Price includes additional shipping charge due to weight and length.


The inside "point" of the rail cover stands approximately 1/4 inch high.  Therefore, there is a good possibility that the existing rail will need ground down with a hand grinder, especially if it is rounded, so that the new cover will seat properly.

It is recommended to thoroughly degrease and clean the track prior to installing the Screen Door Track Cover.  A degreaser such as Purple Power or Simple Green should be applied, let set for a few minutes to thoroughly eat the grease and oil, wiped off with a clean rag then apply rubbing alcohol on the area and wipe to insure all the grease and oil and degreaser is removed before adhering cover.

It is also suggested to rough up both the cover and the area the cover is to be applied with 60 or 80 grit sandpaper so the adhesive has a good surface to "bite" into.

The adhesive tacks up in about 10 minutes, gets decently hard within an hour and completely hardens within 24 hours.  Therefore, the door could be used within an hour since most of the force is horizontal or side to side and not vertical or up and down.

Customer Reviews

Based on 2 reviews Write a review